ROUTER ON A STICK OSPF REQUIRED PC

The router will accept the tagged VLAN traffic on its trunk interface and route traffic between different VLANs. Let us create a Router on stick setup where a single router interface is configured as a trunk link. To configure Router on stick inter-VLAN mechanism,you need to configure the routerвЂ™s interfaces as trunk links. You can configure multiple VLANs on a single interface using Router on stick inter-VLAN mechanism. In this setup, you are configuring each VLAN on a separate router interface.

ROUTER ON A STICK OSPF REQUIRED PC

Also, PC 1 is configured on VLAN 10 and PC 2 is configured on VLAN 20. The switch ports Fa0/4 and Fa0/3, which are also the part of VLANs 10 and 20 respectively, are configured to router interfaces. The Switch SW1 has two VLANs VLAN 10 and VLAN 20 configured on interfacesFa/08 and Fa0/11 respectively. The following figure explains the scenario. The router accepts traffic on its interface from one VLAN through switch and routes the traffic to another VLAN. In a traditional inter-VLAN routing setup, each router interface is connected to a separate network through a switch port, which is also associated with a specific VLAN. To allow communication between different VLANs you can configure inter-VLAN routing between them. > Configure and verify interVLAN routing (Router on a stick)Д¬onfigure and verify interVLAN routing (Router on a stick)Д®xam: Cisco 200-301 - Cisco Certified Network Associate (CCNA)Д«y default the devices on the same VLAN only can communicate with each other.

Router on a stick ospf required